Crownline Owner's Forum - Walk thru windshield need adjusting

Welcome to Crownline Owner's Forum Sign in | Join | Help

Crownline Owner's Forum » Crownline Owners Forum » General Discussion - Boating O... » Walk thru windshield need adjusting

Walk thru windshield need adjusting

Last post 10-16-2008, 8:45 AM by John Reeves. 4 replies.


	Sort Posts: Previous Next

10-13-2008, 10:49 AM 55721

Mario David
Joined on 06-04-2008
Posts 10

Walk thru windshield need adjusting

Reply Quote

I have a 1995 BR202 and the walk thru windshield aligns fine at the bottom end but is off by at least ½” at the top. Is there any way of adjusting this?

Thanks

Needs Attention

10-13-2008, 1:20 PM 55726 in reply to 55721

Kerry Miller
Joined on 06-20-2006
Waukesha Wisconsin
Posts 1,165

Re: Walk thru windshield need adjusting

Reply Quote

Mario,

You could try adjusting the screws on the hinge. The only thing you can do is line up the gap. Let us know how it works.

Kerry

"I would rather be lost on the lake than found at home"

Needs Attention

10-13-2008, 1:49 PM 55729 in reply to 55726

Mario David
Joined on 06-04-2008
Posts 10

Re: Walk thru windshield need adjusting

Reply Quote

Could the windshields spread apart? if so how do you get them back in place. This seemed to just have happend.

Needs Attention

10-13-2008, 2:58 PM 55733 in reply to 55729

Mike O'Neil
Joined on 06-20-2006
St. Louis / 69 mm Lake of the Ozarks, MO
Posts 2,216

Re: Walk thru windshield need adjusting

Reply Quote

They do spread. Mine sometimes closes up at the top. I just give it a push outward on both sides and it's perfect again.

O'
"Little Mascara 3"
2003 266BR,496 MAG w/Bravo III

Needs Attention

10-16-2008, 8:45 AM 55874 in reply to 55733

John Reeves
Joined on 07-03-2006
Buford, GA
Posts 103

Re: Walk thru windshield need adjusting

Reply Quote

On the outside bottom of the windshield you will see a black rubber strip that runs parallel to the windshield. Pull that strip out and you will see the screws that hold the windshield in place. I'll bet the screws have worked themselves loose and the windshield drifted a little. When tightening the screws, be careful not to strip the holes in the fiberglass.

2001 202BR 5.0 EFI B3
"Calico Jack"

Needs Attention